You are not authorised to view this resource.

Multi Grip

Multi use connecting ancillary used to simplify structural joining in timber roof, wall, ceiling and floor framing

Pre-punched and formed galvanised steel timber connectors ideal for:

Tying down trusses for structures located in an area of relatively low wind loading.

Suitable for connecting studs to wall plates, timber braces to roof trusses or for face fixing beams.

Joining timber components rapidly and efficiently.


Option A

Jack flyovers to truncated truss

Ceiling joist to hanging beam

Studs to bottom plates

Truss to top plate

Joint groupTie down Capacity (kN) per Multi Grip Dead load + Wind load
J2 4.3
J3 3.1
J4 2.2
JD3 4.3
JD4 3.1
JD5 2.5

NOTES: The capacities are derived from AS1720-2010 and are for uplift in houses where failure is unlikely to affect an area greater than 25m2. For primary elements in structures other than houses or elements in a house for which failure would be greater than 25m2 these capacities must be multiplied by 0.94. For primary joints in essential services or post disaster buildings multiply by 0.88. For 2/Multi Grips the above values can be doubled.

Option B

Joint GroupCapacity (kN) per Multi Grip
 Dead loadDead load + Floor LLDead Load + Roof LLDead Load + Wind Load
J2 2.2 2.7 3.0 5.4
J3 1.6 2.0 2.1 3.8
J4 1.1 1.3 1.5 2.7
JD3 2.2 2.7 3.0 5.4
JD4 1.6 2.0 2.1 3.8
JD5 1.3 1.6 1.7 3.2


Multi Grips should be secured with at least 10/30mm x 2.8Ø Multinail nails. You can bend the bottom legs to suit a variety of applications as shown in Option A


Manufactured from 1.0mm Galvanised G300 Z275 Steel

DescriptionProduct CodeReference CodeCarton quantityCarton kg.
Multi Grip TA402 MUG-200 200 8.0
Multi Grip TA404 MUG-400 400 16.0
30mm x 2.8Ø Multinail Nails (TA302)